Benchmark DAC1 HDR Manuál s instrukcemi Strana 14

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 67
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 13
DAC2 Series Instruction Manual Rev C Page 14
lit, this indicates that the signal coming into
the DAC is DSD.
Status Codes:
Single LED lit – ‘Normal’ operating
condition with selected input
Single flashing LED – error condition
on selected input except A1 and A2
All LED’s lit – ‘Mute’ mode
All LED’s lit except selected input
‘Dim’ mode
No LED’s lit – ‘OFF’ mode or no power
Error Indication
The Input Status Display will flash when an
error occurs on the selected digital input. The
type of error is indicated by the frequency of
the flashes.
Error Codes:
Very slow flashes – No signal – audio
muted
Slow flashes – Data transmission errors or
Non-PCM –audio muted
Rapid flashes – Non-audio – audio muted
Very rapid flashes – Invalid sample (v-bit)
– no mute
Common causes of errors are:
- Disconnected cable
- Data drop-outs due to a bad cable
- Incompatible data type (AC3, ADAT, etc.)
- Non-Audio data
There is no error indication on the analog
inputs.
Button Functions
Power – Turns the unit on and off. Press
once to turn on. Press once to enter standby
mode, press twice to turn off.
Dim/Mute – Pressing the button will engage
or disengage the dim and mute function. If
the button is held down for more than 2
seconds, it will engage the Home Theater
Bypass/High Throughput on the selected
channel. The HT yellow light will turn on in
conjunction with the input that is designated
with the Home Theater Bypass/High
Throughput.
Polarity – Toggles the polarity of the
selected input (digital inputs only). LED is on
when polarity is inverted.
Input – Press the input select buttons to
change the input. To switch between USB 1.1
and 2.0, plug in the USB to your computer.
Select the USB input, then hold down both
the top and bottom input buttons until either
the 4X (USB 2.0) or 2X (USB 1.0) flashes.
More information can be found on the next
section.
USB Mode Selection
To change the USB mode, plug in your DAC2
into the computer through the USB. Select
the USB input, and then press and hold both
input select buttons (on the faceplate). After
holding the buttons for 2 seconds, either the
4X LED or the 2X LED will flash once
indicating the new USB mode. The 4X LED
flash indicates that the unit is engaged in USB
2.0 for up to 24-bit/192 kHz file playback.
The 2X LED flash indicates that the unit is
engaged in USB Audio 1.1 for up to 24-
bit/192 kHz playback. The 4X or 2X LED will
flash once every time the USB input is
selected. This flash provides an indication of
the USB mode. It is very important your
computer playback is stopped before
changing the USB mode. Doing so might
freeze your computer. Pressing and holding
the USB button on the remote for 2 seconds
will also change the USB mode.
Zobrazit stránku 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

Komentáře k této Příručce

Žádné komentáře